Skip to content

Gas Leak Detection Elermore Vale

Gas leak detection in Elermore Vale starts with safety: everyone out, switches left alone, and the gas network's emergency line rung from outside. After that, a licensed gas fitter tracks down the leak, quotes the repair and fixes it. This work sits under our gas fitting services, alongside what your plumber in Elermore Vale covers.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Gas fitter at work on a kitchen oven

What Are the Signs of a Leak?

Act on any of these:

  • A rotten-egg smell, which comes from the odourant put into natural gas so a leak can be noticed
  • Cooktop flames burning yellow or lazy orange instead of a crisp blue
  • A faint hiss near a bayonet point, an appliance or a wall that carries a gas line
  • A heater that smells as it lights, or an appliance that keeps shutting down
  • Headaches or light-headedness in the house that clear once you step outside

Trust your nose. A slight smell at a fitting can grow, and a detector confirms it on the spot.

Gas cooktop burner alight
Plumber beside a newly installed continuous-flow gas hot water unit

How Do We Find It?

The search follows a set order, and the gear does the finding:

  1. 1

    Shut off and prove it

    The supply is isolated at the meter and the line put under a pressure test, which shows whether gas is escaping at all.

  2. 2

    Follow the pipe

    A handheld gas detector works from the meter towards each appliance, checking every fitting, joint and wall cavity on the way.

  3. 3

    Mark and price

    Once the source is pinned down, you get a set price to fix it before anything is cut open.

  4. 4

    Fix and retest

    The faulty part is replaced, the pressure test is repeated, and each appliance is checked for safe operation.

If the reading points to the meter or the network's side of it, the gas network's crew takes that part, and we give you their number.

What Moves the Price?

  • Where the leak is A loose fitting behind a cooktop is quicker than a pipe inside a brick wall or under the floor
  • What has to come apart Getting behind brickwork or into a ceiling space adds time compared with a fitting under a sink
  • The pipe around it If the neighbouring pipework is just as old, swapping that length while it is exposed can be the better repair
  • Night calls A gas smell chased after hours is charged at the after-hours rate, which is given to you first

Old Fittings Behind Renovated Walls

Fittings from another era

Elermore Vale's brick-veneer houses were built from the mid-1960s through the 90s, and when owners renovate a kitchen or laundry now, the gas fittings behind the wall can be decades older than the new benchtop.

Why renovations are the moment

A connection that has held for thirty or forty years gives no warning before it starts to weep, and a slow seep is noticed by smell long before anything fails outright. With the wall open and the old copper in view, testing the line and swapping dated fittings is simpler than it will ever be again.

If you are mid-renovation, our gas appliance installation work covers the new connections, and gas hot water units are handled through the hot water page.

"We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested" Lee

When We're Not the Right Call

Faults at the meter or on the street supply are for the gas network's own technicians. An electric oven fault or a tripping circuit needs an electrician instead. We sort out which it is when you ring, before anyone is booked.

From Your Call to the Repair

  1. 01

    Ring or send the form

    Call (02) 4063 1232 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 02

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 03

    Found, priced, fixed

    The detector locates the escape, you approve the figure, and the repair is made and retested under pressure before the van leaves.

  4. 04

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

Gas Leak Questions From Elermore Vale

What should I do first if I can smell gas in my Elermore Vale home?

Walk everyone out and away from the building, and leave switches, appliances and phones untouched while you are inside. Once you are clear, ring the gas network's emergency line, then call us on (02) 4063 1232 so a gas fitter can find and fix the fault after the danger is dealt with.

Do you find leaks in the older brick-veneer houses around here?

Yes. Renovations on the 1970s to 90s brick homes around Elermore Vale uncover dated fittings, and older connections are where gas escapes. We prove it with a detector and a pressure test rather than a guess.

Is a leak at the meter itself your job?

No. The meter and the supply pipe feeding it belong to the network, whose crew handles faults there. From the meter's outlet onward is our work, and before anything is touched we establish whose side of the meter the fault sits on.

Can the repair happen as soon as the leak is found?

Where the fault is a fitting, a joint or a short length of pipe, yes: you get the figure, approve it, and the repair goes ahead. A larger job, like a run buried in a wall, is priced in full before anything is opened.

Need a plumber? Call or send the form

Call (02) 4063 1232 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1232

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1232 Get a quote