Skip to content

Gas Fitter Elermore Vale

Elermore Vale Plumbing Co is the gas fitter for Elermore Vale: new cooktops, space heaters and outdoor BBQ points connected, gas leaks traced and repaired, and dated fittings replaced when renovations expose them. You get a fixed figure before work starts, and every job carries our 365-day warranty on all work.

The wider trade, from blocked drains to hot water, is on the Elermore Vale Plumbing Co home page. This hub covers the gas side of it, from a new cooktop to a leak that needs finding tonight.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Plumber working on a gas oven connection

Elermore Vale Gas Fitting Services

The gas work splits two ways, and both have a page:

Gas Appliance Installation

  • Kitchen, heating and outdoor appliances hooked up to the gas line
  • Fresh copper or polyethylene pipe laid to the new position and tested
  • Gas appliance installation

Gas Leak Detection and Repair

  • Gas smells traced with detectors, lines pressure-tested
  • Leaks found and repaired on the property side, with paperwork to close it out
  • Gas leak repairs

Gas hot water also runs through this trade. Storage and continuous-flow units both need a licensed gas fitter, and the hot water page explains how that work is sized and quoted.

Freestanding gas cooker connected in a kitchen

What gas work do older brick houses need?

The suburb's houses went up in one brick-veneer wave, and their gas fittings have sat in walls and under floors ever since. The work that comes out of that stock splits into four clear jobs:

  • A renovation that opens a kitchen or laundry wall and finds old copper or outdated connections behind it
  • A new appliance, like a cooktop or a heater, needing a fresh line from the meter
  • A BBQ bayonet point or an outdoor heater connection for the entertaining area
  • A suspected leak, from a faint smell near a meter to a line failing its pressure test

Each of those is quoted on what the job actually needs, not on a guess.

Renovations bring the old gas work to light. The 1970s to 90s brick-veneer houses that define this suburb are well into their renovation years, and the fittings behind their walls were installed for a different era of appliances. Census figures show 79.2 per cent of homes here standing on their own block, so these are roomy renovation jobs rather than tight unit work. Where a dated fitting turns up mid-build, sorting it before the plasterer closes up saves a second opening later.

Plumber beside a newly installed continuous-flow gas hot water unit

How the gas work runs

  1. 1

    Ring or send the form

    Call (02) 4063 1232 or use the form to explain the fault. We ask enough to bring the right equipment the first time.

  2. 2

    A fixed price first

    A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.

  3. 3

    Tested before handover

    The appliance is commissioned, the line is pressure-checked and leak-tested, and you see the result before we pack up.

  4. 4

    Covered for a year

    Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

How a gas quote is built

That matters because gas work hides its difficulty until the meter and the appliance are both in view. What shapes the figure:

  • The appliance: a single outdoor bayonet is less work than hooking up a full kitchen
  • Distance: how much new pipe the job needs, and what it has to pass through
  • Access: threading pipe through a finished wall or a low subfloor is slower than an open run
  • Timing: chasing a fault after dark costs more than a weekday visit, and you hear the rate first

How do you know a fitting is failing?

Gas lines fail quietly, so the signs are worth knowing before a smell tells you:

  • Burners that flicker yellow or orange rather than burning blue
  • A heater that smells faintly of gas when it starts
  • An appliance that keeps cutting out for no clear reason
  • A pressure test the line cannot pass, which means gas is escaping somewhere

Detectors find the source without pulling the house apart. If any of that sounds familiar, the gas leaks page explains how the trace works and what the repair involves.

Gas fitter at work on a kitchen oven

When We're Not the Right Call

Faults at the meter, or in the service pipe running in from the street, are the gas network's. It runs its own emergency line, and with a gas smell in the house that call comes first. Electric ignition that has lost power is an electrician's fault to find.

What Customers Say

We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
Lee

Gas Questions From Elermore Vale Homes

Do you install gas cooktops in Elermore Vale homes?

Yes. We connect new cooktops and ovens, run copper or polyethylene line to them where needed, commission the appliance and leak-test the whole run before we leave. The figure covers the pipework and the appliance connection, and you approve it before work begins.

Can an older brick-veneer house here switch to gas cooking?

Yes, if a line can reach the kitchen. A licensed gas fitter checks the route from the meter, quotes the pipework up front, and tests the existing fittings while the walls are open. Renovations on the suburb's 1970s to 90s brick houses turn up dated fittings, and replacing them during the build saves opening the wall twice.

Is a gas smell in an Elermore Vale home an emergency?

Treat it as one. Leave the house, leave the switches and any flame alone, and ring the gas network's emergency line once you are outside. When the network has made the property safe, we find and fix the leak on the house side of the meter, retest the line and issue the paperwork.

Do you do gas work after hours in Elermore Vale?

Yes. We are Available 24/7, and a gas fault at night is booked the same way as a daytime one: you describe the problem, we bring the detection gear, and the after-hours rate is stated before we come.

Need a plumber? Call or send the form

Call (02) 4063 1232 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1232

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1232 Get a quote